Thesis
The development of a simplified modeling technique for the finite element analysis of reinforced masonry shear walls
Washington State University
Master of Science (MS), Washington State University
2011
Handle:
https://hdl.handle.net/2376/100081
Abstract
Reinforced masonry shear walls are structural elements that are commonly used in construction. It is important to properly model their contribution to the strength and stiffness of the structures in which they appear. Analysts typically represent these shear walls with deep beam elements within building models. However, the assumption that a shear wall behaves as a deep beam breaks down when shear failure occurs, and cracking starts to dominate the behavior of the wall. There is a need to develop a finite element model of these shear walls that is accurate but simple enough to be included as a part of a full building model. A 2-D masonry shear wall model was developed to meet these requirements. To make it applicable within standard structural analysis software, the model does not require a detailed representation of each component of the wall separately. Instead, the reinforcing is smeared and overlaid with a plane stress masonry element. Plasticity is assumed for the steel and cracking/damage is assumed for the masonry. Reductions in masonry stiffness were applied to account for initial cracks, and artificial damping was added to stabilize the solution process after the occurrence of masonry damage. Data from two experimental test programs were used to verify the proposed modeling technique along with comparisons with detailed finite element models. It was found that the behavior of the simplified models was quite close to that of the detailed finite element models for all cases considered. When compared to the peak values of cyclic load of the experimental specimens, it was found that initial stiffness, peak load, and displacement at final failure were well predicted although, for short shear walls which are dominated by shear failure of the masonry, damage did not evolve as rapidly in the finite element models as was observed in the experimental specimens. The proposed modeling technique was therefore shown to reasonably predict reinforced masonry shear wall behavior, even with coarse meshing and smeared steel reinforcement, regardless of the wall aspect ratio, amount of axial vertical load applied to the wall, and reinforcement ratio.
Metrics
21 File views/ downloads
14 Record Views
Details
- Title
- The development of a simplified modeling technique for the finite element analysis of reinforced masonry shear walls
- Creators
- Mohammed Ibrahem Abdellatef
- Contributors
- William F. Cofer (Degree Supervisor)
- Awarding Institution
- Washington State University
- Academic Unit
- Civil and Environmental Engineering, Department of
- Theses and Dissertations
- Master of Science (MS), Washington State University
- Publisher
- Washington State University; Pullman, Wash. :
- Identifiers
- 99900525187701842
- Language
- English
- Resource Type
- Thesis